Refinishing wood gun stocks

refinishing wood gun stocks

I want to create an instructable for refinishing gun stocks. I have done some To fix this problem you need to secure the wood fibers back together 5. Sanding!. Everything you need to finish a new stock or to refinish an old stock. - Kit includes: 3 oz Tru-Oil Gun Stock Finish, 3 oz Walnut Stain, 3 oz Stock If using an oily wood, you can try using mineral spirits to thin out the Tru-Oil or seal the. Okay so you need to know how to finish or refinish a gun stock. Sanding removes wood unnecessarily, may make for a wavy surface, and ruins positive. refinishing wood gun stocks Once this has dried, go back and sand the surface till it is even with the wood. Keep the damp cloth between the iron and the wood, move the iron around so you sharpening husqvarna chainsaw overdo it in any one spot, and be careful not to gouge the stock with the pointed end of the iron. Many oil finishes may go darker with refinishing wood gun stocks and also mask the natural beauty of a good piece of walnut. Another thing to keep in mind is to do just one side at a time. I usually will pour the paint finishing right from the can and use a bristle brush or even a rag to spread it over the stock surface. If you had plastic fittings on your stock, you want to be very careful not to get the stripper on it. Another trick is to take a lit match and pass it a few times over the epoxy.

Video

"Stock Refinishing Part 1- Removing the old finish"

Refinishing wood gun stocks - woodworkingplans build

Be sure to use the right tools for the job and don't rush it! They also tend to darken the stock and some of these finishes appear to have a stain component in them that tends to heighten this effect. Thanks for the instructable. Rubbing in the direction of the grain pulls the filler out of the pores in the wood, while scrubbing across the grain will insert the French Red more deeply into the pores. This is that lovely colorant and filler that I talked about earlier, so you may want to apply some more stripper and scrape some more. Going to fill them in before staining. Buff the final coat with carnauba wax to help protect your wood against mositure. Safety gear gloves, eye protection If you still have some dings, try spot steaming them with a wet rag, and use the point of the hot steam iron. The Steel wool is a great point! French Red is an old favorite with stock makers because it is a good grain filler that also duplicates the rich, walnut-hued stains typically used by gunmakers. Many oil finishes may go darker with time and also mask the natural beauty of a good piece of walnut.

0 comments on “Refinishing wood gun stocks”:

Leave a Reply

Your email address will not be published. Required fields are marked *